GSO IEC 62150-1:2014
IEC 62150-1:2005
Gulf Standard
Current Edition
·
Approved on
25 December 2014
Fibre optic active components and devices - Test and measurement procedures - Part 1: General and guidance
GSO IEC 62150-1:2014 Files
English
19 Pages
Current Edition
Reference Language
Obtaining this standard through the store is currently unavailable.
You can acquire it directly from its source or from one of the member countries stores
GSO IEC 62150-1:2014 Scope
This part of IEC 62150 contains a series of performance test procedures, including preferred
severities designed to assess the ability of active components to perform under expected
service conditions. This part of IEC 62150 provides general information that applies to all of these
procedures.
The object of this standard is to provide uniform and reproducible environmental test
procedures and measurement procedures, for those preparing specifications for fibre optic
active components and devices.
These test and measurement procedures are based on available international engineering
experience and judgement, and are designed to provide information on the following
properties of active components:
a) ability to operate within specified limits of temperature, pressure. humidity, mechanical
stress or other environmental conditions and certain combinations of these conditions;
b) ability to withstand storage and transport;
c) ability to meet the specified levels of optical performance.
Active optical components considered in the present standard are those specified in the
IEC 62007, IEC 62148 and IEC 62149 series.
The tests in this standard permit the performance of sample components or equipment to be
compared. To assess the overall quality of a production lot, the test procedures should be
applied in accordance with a suitable sampling plan and may be supplemented by appropriate
additional tests, if necessary.
To provide tests appropriate to the different intensities of an environmental condition, some of
the test procedures have a number of degrees of severity. These different degrees of severity
are obtained by varying the time, temperature or some other determining factor separately or
in combination.
This standard should be used in combination with the detail specification, which will define the
tests to be used, the required degree of severity for each of them, their sequence, if relevant,
and the permissible performance limits. In the event of conflict between this basic standard
and the detail specification, the latter will apply.
Best Sellers From Electrical Sector
GSO 2530:2016
Gulf Standard
Energy Labelling And Minimum Energy Performance Requirements For Air-Conditioners
GSO 34:2007
Gulf Technical Regulation
LEAD-ACID STARTER BATTERIES USED FOR
MOTOR VEHICLES AND INTERNAL
COMBUSTION ENGINES
GSO 35:2007
Gulf Standard
Methods of test
for lead-acid starter batteries used for motor vehicles
and internal combustion engines
GSO 1899:2016
Gulf Standard
GCC Standard voltages and frequencies for AC transmission and distribution systems
Recently Published from Electrical Sector
GSO IEC 63522-32:2026
IEC 63522-32:2025
Gulf Standard
Electrical relays - Tests and measurements - Part 32: Acoustic noise
GSO IEC 61362:2026
IEC 61362:2024
Gulf Standard
Guidelines to specification of hydraulic turbine governing systems
GSO IEC TS 62271-313:2026
IEC TS 62271-313:2025
Gulf Standard
High-voltage switchgear and controlgear - Part 313: Direct current circuit-breakers
GSO IEC TR 63411:2026
IEC TR 63411:2025
Gulf Standard
Grid connection of offshore wind via VSC-HVDC systems