GSO EN 17240:2025

EN 17240:2024
Gulf Standard   Current Edition · Approved on 14 October 2025

Intelligent transport systems - ESafety - ECall end to end conformance testing for IMS packet switched based systems

GSO EN 17240:2025 Files

GSO EN 17240:2025 Scope

This document defines the key actors in the eCall chain of service provision using IMS over packet switched networks (such as LTE/4G) as: 1) In-vehicle system (3.20) (IVS)/vehicle, 2) Mobile network Operator (MNO), 3) Public safety answering point (3.27) (PSAP), and to provide conformance tests for actor groups 1) - 3). NOTE 1 Conformance tests are not appropriate nor required for vehicle occupants (3.36), although they are the recipient of the service. NOTE 2 Third party eCall systems (TPS eCall) are not within the scope of this deliverable. This is because the core TPS-eCall (3.32) standard (EN 16102) does not specify the communications link between the vehicle and the TPS service provider (3.29). NOTE 3 These conformance tests are based an the appropriate conformance tests from EN 16454 which was published before Internet Protocol multimedia Systems (IMS) packet switched networks were available. This deliverable therefore replicates the appropriate tests from EN 16454 (and acknowledge their source); adapt and revise Conformance Test Protocols (CTP) from EN 16454 to an IMS paradigm; or provide new additional tests that are required for the IMS paradigm. Some 14 112-eCall (Pan European eCall) tests provided in EN 16454 are specific to GSM/UMTS circuit switched communications and not appropriate for the IMS paradigm and are therefore excluded from this deliverable. This document therefore provides a suite of ALL conformance tests for IVS equipment, MNO's, and PSAPS, required to ensure and demonstrate compliance to CEN/TS 17184. NOTE 4 Because in the event of non-viability or non-existence of an IMS supporting network at any particular time/location, IMS-eCall systems revert to CS networked eCall systems eCall via GSM/UMTS, IVS and PSAPs need to support, and prove compliance to both IMS and CS switched networks. The Scope covers conformance testing (and approval) of new engineering developments, products and systems, and does not imply testing associated with individual installations in vehicles or locations.

Best Sellers From Mechanical Sector

GSO 42:2015
 
Gulf Technical Regulation
MOTOR VEHICLES - GENERAL REQUIREMENTS
GSO 159:1993
 
Gulf Technical Regulation
MOTOR VEHICLES – DIMENSIONS AND WEIGHTS
GSO 98:1988
 
Gulf Technical Regulation
MOTOR VEHICLES- FLAMMABILITY OF INTERIOR MATERIALS AND THEIR TESTING METHODS
GSO 2698:2022
 
Gulf Standard
Technical Requirements for Electric Vehicles

Recently Published from Mechanical Sector

GSO 1796:2007
 
Gulf Standard
Methods of test for two pieces aluminum round cans used for canning food (Beverages & stuffs
GSO 230:2005
 
Gulf Standard
MOTOR VEHICLES — BRAKE FLUID – SIMULATED SERVICE PERFORMANCE TEST
GSO 1584:2002
 
Gulf Standard
Agricultoral equipment - roll over protection structures for agricultural tractors.
GSO 137:1991
 
Gulf Standard
Plastics and cellular plastics – Part 1: standard atmospheres for Conditioning and testing, Determination of linear dimensions and Test for dimensional stability