GSO ISO 16422-2:2025

ISO 16422-2:2024
Gulf Standard   Current Edition · Approved on 14 October 2025

Pipes and joints made of oriented unplasticized poly(vinyl chloride) (PVC-O) for the conveyance of water under pressure — Part 2: Pipes

GSO ISO 16422-2:2025 Files

English 25 Pages
Current Edition Reference Language

GSO ISO 16422-2:2025 Scope

This document specifies the characteristics of solid-wall pipes made of oriented unplasticized poly(vinyl chloride) (PVC-O) for piping systems intended to be used underground or above-ground (where protected from direct sunlight), for water supply, buried drainage, sewerage, treated wastewater and irrigation under pressure. It also specifies the test parameters for the test methods referred to in this document.

In conjunction with ISO 16422-1 and ISO 16422-5, this document is applicable to oriented PVC-O pipes, with or without integral socket, intended to be used for the following:

a)       water mains and services lines;

b)       conveyance of water for both outside and inside buildings;

c)        drainage, sewerage and treated wastewater under pressure;

d)       irrigation under pressure.

This document is applicable to piping systems intended for the supply of water under pressure up to and including 25 °C (cold water), intended for human consumption and for general purposes as well as for wastewater under pressure.

This document is also applicable to components for the conveyance of water and wastewater up to and including 45 °C. For temperatures between 25 °C and 45 °C, see Figure C.1.

The piping system according to this document is intended for the conveyance of cold water up to pressures of 25 bar[1] and especially in those applications where special performance requirements are needed, such as impact loads and pressure fluctuations, up to pressure of 25 bar.

[1]  1 bar = 0,1 MPa = 105 Pa; 1 MPa = 1 N/mm2

Best Sellers From Mechanical Sector

GSO 42:2015
 
Gulf Technical Regulation
MOTOR VEHICLES - GENERAL REQUIREMENTS
GSO 159:1993
 
Gulf Technical Regulation
MOTOR VEHICLES – DIMENSIONS AND WEIGHTS
GSO 98:1988
 
Gulf Technical Regulation
MOTOR VEHICLES- FLAMMABILITY OF INTERIOR MATERIALS AND THEIR TESTING METHODS
GSO 2698:2022
 
Gulf Standard
Technical Requirements for Electric Vehicles

Recently Published from Mechanical Sector

GSO ISO 8210:2026
ISO 8210:2021 
Gulf Standard
Equipment for harvesting — Combine harvesters — Test procedure and performance assessment
GSO ISO 8741:2026
ISO 8741:2025 
Gulf Standard
Fasteners — Reverse-taper grooved pins — Half-length progressive grooves
GSO ISO 8740:2026
ISO 8740:2025 
Gulf Standard
Fasteners — Parallel grooved pins, with chamfer point — Full-length diamond grooves
GSO ISO 34505:2026
ISO 34505:2025 
Gulf Standard
Road vehicles — Test scenarios for automated driving systems — Scenario evaluation and test case generation