GSO EN 50643:2024

Gulf Standard   Current Edition
· Approved on 31 January 2024 ·

Electrical and electronic household and office equipment - Measurement of networked standby power consumption of edge equipment

Office machines
Including typewriters, dictation equipment, addressing machines, letter opening machines, letter folding machines, postal franking machines, their ribbons and other accessories, etc.
Domestic electrical appliances in general
Including water-bed heaters and electric blankets

GSO EN 50643:2024 Files

GSO EN 50643:2024 Scope

1.1 Equipment in the scope of this standard This European Standard specifies methods of measurement of electrical power consumption in networked standby and the reporting of the results for edge equipment. Power consumption in standby (other than networked standby) is covered by EN 50564, including the input voltage range. This European Standard also provides a method to test power management and whether it is possible to deactivate wireless network connection(s). NOTE 1 This standard has been written in particular to support Commission Regulation (EU) No 801/2013 for the measurement of energy consumption in networked standby. This standard applies to electrical products with a rated input voltage of 230 V a.c. for single phase products and 400 V a.c. for three phase products. NOTE 2 The measurement of energy consumption and performance of products during intended use are generally specified in product standards and are not covered by this standard. NOTE 3 The term "products" in this standard includes household appliances or information technology products, consumer electronics, audio, video and multimedia systems; however the measurement methodology could be applied to other products. Where this standard is referenced by more specific standards or procedures, these should define and name the relevant conditions to which this test procedure is applied. 1.2 Equipment not in the scope of this standard This European Standard does not apply to the measurement of electrical power consumption in networked standby for interconnecting equipment. NOTE Measurement of electrical power consumption in networked standby for interconnecting equipment is the subject of ETSI standard EN 303 423 "Environmental Engineering (EE) - Electrical and electronic household and office equipment; Measurement of networked standby power consumption for interconnecting equipment".

Best Sellers From Electrical Sector

GSO 2530:2016
 
Gulf Standard
Energy Labelling And Minimum Energy Performance Requirements For Air-Conditioners
GSO 34:2007
 
Gulf Technical Regulation
LEAD-ACID STARTER BATTERIES USED FOR MOTOR VEHICLES AND INTERNAL COMBUSTION ENGINES
GSO 35:2007
 
Gulf Standard
Methods of test for lead-acid starter batteries used for motor vehicles and internal combustion engines
GSO 2693:2022
 
Gulf Standard
The GCC Terrestrial Radio Receiver Specifications for AM/FM/T-DAB+

Recently Published from Electrical Sector

GSO IEC 63296-1:2024
IEC 63296-1:2021 
Gulf Standard
Portable multimedia equipment - Determination of battery duration - Part 1: Powered loudspeaker equipment
GSO IEC 61558-2-4:2024
IEC 61558-2-4:2021 
Gulf Standard
Safety of transformers, reactors, power supply units and combinations thereof - Part 2-4: Particular requirements and tests for isolating transformers and power supply units incorporating isolating transformers for general applications
GSO IEC 60335-2-23:2024
IEC 60335-2-23:2016 
Gulf Standard
Household and similar electrical appliances - Safety - Part 2-23: Particular requirements for appliances for skin or hair care
GSO IEC 61558-2-16:2024
IEC 61558-2-16:2021 
Gulf Standard
Safety of transformers, reactors, power supply units and combinations thereof - Part 2-16: Particular requirements and tests for switch mode power supply units and transformers for switch mode power supply units for general applications