GSO OIML D31:2023
Gulf Standard
Current Edition
·
Approved on
03 May 2023
·
General requirements for software controlled measuring instruments
GSO OIML D31:2023 Files
No files are available for this standard right now!
GSO OIML D31:2023 Scope
This International Document specifies the general requirements applicable to legally relevant software-related functionality and security in measuring instruments and gives guidance for verifying the compliance of an instrument with these requirements.
This Document shall be taken into consideration by the OIML Technical Committees and Subcommittees as a basis for establishing specific software requirements and procedures in OIML Recommendations applicable to particular categories of measuring instruments (hereafter termed “relevant Recommendations”).
The instructions given in this Document apply only to software-controlled measuring instruments or their components.
Note 1: This Document does not cover all the technical requirements specific to software-controlled measuring instruments; these requirements are to be given in the relevant Recommendation, e.g. for weighing instruments, water meters, etc.
Note 2: This Document addresses some aspects concerning data security. In addition, national regulations for this area need to be considered.
Best Sellers From Metrology Sector
GSO OIML R87:2021
OIML R87:2016
Gulf Standard
Quantity of product in prepackages
GSO OIML R79:2021
OIML R79:2015
Gulf Standard
Labeling requirements for prepackages
GSO OIML R 76-1:2009
OIML R 76-1:2006
Gulf Standard
Non-automatic weighing instruments –
Part 1: Metrological and technical requirements - Tests
GSO OIML R121:2007
OIML R 121:1996
Gulf Standard
The Scale of Relative Humidity of Air
Certified Against Saturated Salt Solutions
Recently Published from Metrology Sector
GSO ISO 14405-2:2024
ISO 14405-2:2018
Gulf Standard
Geometrical product specifications (GPS) — Dimensional tolerancing — Part 2: Dimensions other than linear or angular sizes
GSO ISO 3455:2024
ISO 3455:2021
Gulf Standard
Hydrometry — Calibration of current-meters in straight open tanks
GSO ISO 10360-10:2024
ISO 10360-10:2021
Gulf Standard
Geometrical product specifications (GPS) — Acceptance and reverification tests for coordinate measuring systems (CMS) — Part 10: Laser trackers
GSO ISO 7626-5:2024
ISO 7626-5:2019
Gulf Standard
Mechanical vibration and shock — Experimental determination of mechanical mobility — Part 5: Measurements using impact excitation with an exciter which is not attached to the structure