GSO ISO 12219-7:2021

Gulf Standard   Current Edition
Approved on  01 July 2021

Interior air of road vehicles — Part 7: Odour determination in interior air of road vehicles and test chamber air of trim components by olfactory measurements

Ambient atmospheres
Including indoor air
Road vehicles in general
Including testing and recycling of road vehicles

GSO ISO 12219-7:2021 Files

GSO ISO 12219-7:2021 Scope

ISO 12219-7:2017 specifies a standardized and objective process to analyse and determine the olfactory behaviour of components, semi-finished products and materials fitted in the interior of road vehicles. The odour determination is either performed by using samples from the interior air of road vehicles or from emission test chamber air. This document describes an olfactory screening method based on different scales for the olfactory assessment which are described in the annexes. Other olfactory assessments, e.g. according to ISO 16000‑28, are also possible but are not the focus of this document.

Best Sellers From Mechanical Sector

GSO 42:2015
 
Gulf Technical Regulation
MOTOR VEHICLES - GENERAL REQUIREMENTS
GSO 159:1993
 
Gulf Technical Regulation
MOTOR VEHICLES – DIMENSIONS AND WEIGHTS
GSO 98:1988
 
Gulf Technical Regulation
MOTOR VEHICLES- FLAMMABILITY OF INTERIOR MATERIALS AND THEIR TESTING METHODS
GSO 1780:2010
 
Gulf Technical Regulation
Motor vehicle-vehicle identification number (vin) - requirements

Recently Published from Mechanical Sector

GSO EN 17038-1:2023
EN 17038-1:2019 
Gulf Standard
Pumps - Methods of qualification and verification of the Energy Efficiency Index for rotodynamic pump units - Part 1: General requirements and procedures for testing and calculation of Energy Efficiency Index (EEI)
GSO EN 14452:2023
EN 14452:2005 
Gulf Standard
Devices to prevent pollution by backflow of potable water - Pipe interrupter with atmospheric vent and moving element DN 10 to DN 20 - Family D, type B
GSO ISO 11298-4:2023
ISO 11298-4:2021 
Gulf Standard
Plastics piping systems for renovation of underground water supply networks — Part 4: Lining with cured-in-place pipes
GSO ISO 5752:2023
ISO 5752:2021 
Gulf Standard
Metal valves for use in flanged pipe systems — Face-to-face and centre-to-face dimensions