GSO ISO 4954:2017

Gulf Standard   ACTIVE

Steels for cold heading and cold extruding

Adoption by Endorsement

Adoption by endorsement for the latest version of this international/national standard and the previous adopted edition remains effective for 2 years starting from the date of last international update

Scope
1.1.1 This International Standard applies to wrought unalloyed and alloyed steels which are intended for cold heading or cold extruding and are delivered as wire rods, wire or bars. It contains five sections covering the following topics: Section 1 - general requirements common to all sections. Section 2 - steels not intended for heat treatment, with diameters from 2 mm to 100 mm. Section 3 - case-hardening steels with diameters from 2 mm to 100 mm. Section 4 - steels for quenching and tempering including boron treated steels, with diameters from 2 mm to 100 mm. Section 5 - stainless steels with diameters of 2 mm up to 25 mm for ferritic, up to 100 mm for martensitic, and up to 50 mm for austenitic steels. 1.1.2 This International Standard (except section 2) is not applicable to the properties of cold-headed or cold-extruded parts which have not been subjected to a subsequent heat treatment. As the properties of the parts in the cold headed or cold extruded and subsequently not-heat-treated condition are largely dependent on the applied coldheading or cold-extruding conditions, these should, if necessary, be a matter of agreement between the purchaser and the manufacturer of the parts. 1.1.3 In addition to this International Standard, the general technical delivery requirements of IS0 404 are applicable. ISO/TR 9769:1991, Steel and iron - Review of avail- - able methods of analysis. IS0 10474:1991, Steel and steel products - Inspection documents.
Endorsement
ISO 4954:1993
03 October 2017
Stainless steels
Including alloyed steels, corrosion-resistant steels, heat-resisting steels, etc.

Files

English
38 Pages
 
 

Best Sellers From Construction and Building Sector

GSO 1914:2009
 
Gulf Standard
Portland Cement
GSO 1418:2002
 
Gulf Technical Regulation
Aluminium and aluminium alloys products for architectural application Part 1 : Sheets, strips, bars and structural Sections .
GSO 938:2009
 
Gulf Standard
Test Methods for Chemical Properties of Portland Cement
GSO 1915:2009
 
Gulf Standard
Test Methods for Physical Properties of Portland Cement ICS :

Recently Published from Construction and Building Sector

GSO ISO 404:2017
ISO 404:2013 
Gulf Standard
Steel and steel products -- General technical delivery requirements
GSO ISO 22282-6:2017
ISO 22282-6:2012 
Gulf Standard
Geotechnical investigation and testing -- Geohydraulic testing -- Part 6: Water permeability tests in a borehole using closed systems
GSO ISO 4954:2017
ISO 4954:1993 
Gulf Standard
Steels for cold heading and cold extruding
GSO ISO 2566-1:2017
ISO 2566-1:1984 
Gulf Standard
Steel -- Conversion of elongation values -- Part 1: Carbon and low alloy steels