GSO ISO 10988:2016
ISO 10988:2011
Gulf Standard
Current Edition
·
Approved on
22 December 2016
Equipment for crop protection -- Knapsack motorized air-assisted sprayers -- Test methods and performance limits
GSO ISO 10988:2016 Files
English
19 Pages
Current Edition
Reference Language
Obtaining this standard through the store is currently unavailable.
You can acquire it directly from its source or from one of the member countries stores
GSO ISO 10988:2016 Scope
This International Standard specifies the requirements, test methods and minimum performance limits for knapsack motorized air-blast (twin-fluid) sprayers and air-assisted centrifugal sprayers as defined in ISO 5681.
It is applicable to those integrally powered knapsack sprayers, equipped with an engine and carried by the operator, intended primarily for use in agriculture and horticulture (hereafter referred to as “sprayers”).
It is not applicable to hydraulic pressure sprayers, thermal sprayers or cold foggers; nor is it applicable to sprayers adapted for the application of dry material.
It addresses general operating parameters as well as the potential deposition of spray droplets under specified controlled conditions. It does not deal with the safety of the operator in the use of the sprayers (see ISO 28139)
Best Sellers From Mechanical Sector
GSO 42:2015
Gulf Technical Regulation
MOTOR VEHICLES - GENERAL REQUIREMENTS
GSO 159:1993
Gulf Technical Regulation
MOTOR VEHICLES –
DIMENSIONS AND WEIGHTS
GSO 98:1988
Gulf Technical Regulation
MOTOR VEHICLES- FLAMMABILITY OF
INTERIOR MATERIALS AND THEIR
TESTING METHODS
GSO 2698:2022
Gulf Standard
Technical Requirements for Electric Vehicles
Recently Published from Mechanical Sector
GSO 1796:2007
Gulf Standard
Methods of test for two pieces aluminum round cans used for canning food (Beverages & stuffs
GSO 230:2005
Gulf Standard
MOTOR VEHICLES —
BRAKE FLUID – SIMULATED SERVICE
PERFORMANCE TEST
GSO 1584:2002
Gulf Standard
Agricultoral equipment - roll over protection structures for agricultural tractors.
GSO 137:1991
Gulf Standard
Plastics and cellular plastics – Part 1: standard atmospheres for Conditioning and testing, Determination of linear dimensions and Test for dimensional stability