GSO OIML R111-2:2007

Gulf Standard   ACTIVE

Weights of Classes E1, E2,F1,F2,M1,M1-2,M2,M2-3 and M3 Part 2: Test Report Format

Scope
The International Organization of Legal Metrology (OIML) is a worldwide, intergovernmental organization whose primary aim is to harmonize the regulations and metrological controls applied by the national metrological services, or related organizations, of its Member States. The two main categories of OIML publications are: • International Recommendations (OIML R), which are model regulations that establish the metrological characteristics required of certain measuring instruments and which specify methods and equipment for checking their conformity; the OIML Member States shall implement these Recommendations to the greatest possible extent; • International Documents (OIML D), which are informative in nature and intended to improve the work of the metrology services. OIML Draft Recommendations and Documents are developed by technical committees or subcommittees which are formed by Member States. Certain international and regional institutions also participate on a consultation basis.
Adoption without modification
OIML R111-2:2004
26 September 2007
Metrology and measurement in general
Including measuring instruments in general, preferred numbers, standard measures, general aspects of reference materials, etc.
Measurement of force, weight and pressure
Including measuring and weighing instruments
 

Best Sellers From Metrology Sector

GSO 1:1990
 
Gulf Standard
The international system of units Part 1: Quantities and base,supplementary and derived units.
GSO 2:1990
 
Gulf Technical Regulation
The international system of units,Part 2: decimal and sub-multiples of the SI units of rules for their use and writing theird symbols.
GSO OIML R21:2009
OIML R 21:2007 
Gulf Standard
Taximeters Metrological and technical requirements, test procedures and test report format
GSO OIML R49-2:2008
OIML R 49-2:2006 
Gulf Standard
Water meters for the metering of cold potable water and hot water. Part 2: Test Methods

Recently Published from Metrology Sector

GSO ISO 14405-3:2021
ISO 14405-3:2016 
Gulf Standard
Geometrical product specifications (GPS) — Dimensional tolerancing — Part 3: Angular sizes
GSO ISO 14511:2021
ISO 14511:2019 
Gulf Standard
Measurement of fluid flow in closed conduits — Thermal mass flowmeters
GSO ISO 11929-3:2021
ISO 11929-3:2019 
Gulf Standard
Determination of the characteristic limits (decision threshold, detection limit and limits of the coverage interval) for measurements of ionizing radiation — Fundamentals and application — Part 3: Applications to unfolding methods
GSO ISO 11171:2021
ISO 11171:2016 
Gulf Standard
Hydraulic fluid power — Calibration of automatic particle counters for liquids