Committee
TC07
Schedule
2019
Prepared By
Stage
DS
Deadline
04/08/2019
DOWNLOAD PROJECT DRAFT AND ADD YOUR COMMENTS

Arabic Title

طريقة اختبار توافق الالستومر في شحوم التزييت والسوائل

English Title

Standard Test Method for Elastomer Compatibility of Lubricating Greases and Fluids

Category

قطاع النفط والغاز Oil and Gas Sector

Scope

1.1 This test method evaluates the compatibility of lubricating greases and fluids with coupons cut from standard elastomer sheets (Practice D3182) or, optionally, from SAE Specification AMS 3217/2C (NBR-L) and AMS 3217/3B (CR) sheets. Compatibility is evaluated by determining the changes in volume and Durometer A hardness that occur when elastomer coupons are totally immersed in a lubricant sample for 70 h at either 100 or 150°C or as required by the lubricant specification.

1.1.1 Some lubricant specifications may require different test conditions, such as longer durations or lower or higher temperatures. In such instances, the repeatability and reproducibility values stated in Section 12 do not apply, and the user and supplier should agree on acceptable limits of precision.

NOTE 1: The scope of this test method now includes the evaluation of the elastomer compatibility of both lubricating fluids and greases. Testing of fluids was not included in Test Method D4289–95 and earlier versions.

1.2 This test method can also be used as a guide to evaluate the compatibility of greases with rubber products not in standard sheet form (Practice D3183).

1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.3.1 Exception—When listed, Durometer A units shall be regarded as the standard.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.For specific warning statements, see 8.4 – 8.6.

Purpose & Justification

لعدم تبنيها على المستوى الخليجي

Type

Adopt

Stanadard No

ASTM D4289-13(2014)e1

References

ASTM D4289-13(2014)e1

Submitted By

Asma Alsalman أسماء السلمان  26/09/2018